HAK 622 Helicopter
CHARGING
1. Helicopter needs to be charged. It takes 1-2 hours to charge it for about 10 minutes of flight.
2. To charge it, disconnect the small red jack from the helicopter and connect it to the red connector on the end of the charging cord. BE CAREFUL WITH THE WIRE AND THE SMALL RED JACKS .. GENTLE IS GOOD.
3. Make sure the power button on the controller is OFF.
4. Plug in the charging cord. The light ON THE CHARGER PLUG will go from RED to YELLOW to GREEN as the helicopter charges. A full charge takes about 90 minutes
5. Disconnect the small red jack on the helicopter from the charging cord and plug it into the jack on the side of the helicopter. The lights in the front of the helicopter should go on.
6. If you are not going to fly it, leave the small red jack disconnected.
USING
1. Put the helicopter in a spot with lots of space. Make sure you connected the wire on the helicopter after charging.
2. Turn on the right sliding switch on the controller. Light on the controller will go on and blink red.
3. Move the top left throttle control all the way up and then all the way back down. The light on the controller will now be solid red and your helicopter is ready to fly. BE CAREFUL!
4. Move the top left throttle up SLOWLY to start the blades and get the helicopter off the ground, then move it back down to land it.
5. If it looks like it is going to crash, immediately move the top left throttle all the way down to stop the blades. Try not to hit anything.
6. After you have mastered UP and DOWN, experiment with the top right controller to turn the copter left or right
7. Don not try to do too much all at once, slow is good.
8. Unplug the wire on the copter when you are done and charge it up for next time.